IMG_0440.JPG XERC 2 SE: IR receiver (soldering complete)

Home > IMG_0440.JPG XERC 2 SE: IR receiver (soldering complete)
Parent Previous Next
 

At this point, I decided to test it out before screwing everything back together again. So I screwed in the motherboard with just one screw, connected the power supply, and plugged it in.

The green LED blinked twice and started the fade on and off cycle. Pressing the DISPLAY button on the remote did not turn on the Xbox. Pressing the power button on the Xbox itself did work. Holding down the power button turned off the Xbox and began configuration mode of the XERC 2 SE.

Something looked to be wrong with the IR receiver, but there were only three wires, and I have pictures to verify I didn't mess up the colors. Tech. support!

http://pablot.com/forums/index.php?topic=239.0

It is a good thing I made the IR receiver wires long so I can flip the motherboard. It's only three wires, but I'm lazy. Lazy is why I bought the XERC 2 SE in the first place.


Click to reduce

Parent Previous Next
 
Home > IMG_0440.JPG XERC 2 SE: IR receiver (soldering complete)

picTree Version: 6.00 - Released 2013-01-320
Created by James C. Pao
Page Created: 2017-05-25 19:36:34
Valid HTML 4.01