Hansgrohe Solaris E Widespread Faucet from Costco 201311

1. Use an allen wrench to loosen the set screw at the back of the spout before installing. Pull the brass part down from the spout. Turn the silver plate to align the hole or hide it as needed for your sink. Push the brass part back to sandwich the silver plate and re-tighten the set screw. You may need to turn the silver plate until it locks firmly against the spout. If you skip this step, your spout may wiggle after installation.
2. Plug/cover the drain with a rag before removing the aerator. This will prevent the rubber washer from dropping down the drain. Typically, the rubber washer sticks up inside the spout so all you see is the plastic screen on the aerator. Make sure you recover the rubber washer before flushing the spout and water lines with water.
3. To prevent water from splashing without the aerator in place, cover the spout with a towel/rag so it drapes down over the drain.

• Costco's web page
• Costco's installation video

• 801292.pdf (3.4MiB, 2013-11-25 10:37:38)